To change the belt, flip the sander onto one side leaving the open side facing up, pull the release handle and the rollers will come slightly together to slacken the belt. Before replacing the belt be certain it is facing the direction indicated (by arrows) on the bottom of the belt – otherwise your sandpaper will be moving in the wrong direction. Slide the belt over the rollers and drop the handle to tighten the belt to the drums. Align the rollers with the sander’s tracking knob to ensure they are exactly parallel. The sander must be engaged to adjust the tracking so be certain the sander is
A belt sander is a power tool that has two parallel drums on its underside that are spun with a motor. A continuous loop of sandpaper, or a sanding belt, is pulled around the drums to sand or level wood and other materials. belt sander are a much rougher tool than most sanders and are generally only required for certain projects demanding quick removal or rough surface leveling. They are also commonly used to remove paint or other finishes from materials. The most conventional belt sanders use 3″ to 4 ” wide belts. These wider sanding belts offer greater working surface area on your materials,
The bulky build of belt sanders, however, helps them withstand some pretty serious shop abuse. They are tough and general maintenance is relatively simple. Mostly you just need to be certain the two cylindrical rollers (drums) the sanding belt sits on remain in perfect alignment. If the rollers are not precisely parallel, the belt will not track in the center of the rollers and will slip off. As a rule, you should try to adjust the rollers each time you change the belt. This can be done with a manual tracking knob on the side of the tool. If your drums are tilted the belt will either push towa
contemplatedauthority 